Search results
Results From The WOW.Com Content Network
Usenet is a worldwide, distributed discussion system that uses the Network News Transfer Protocol (NNTP). Programs called newsreaders are used to read and post messages (called articles or posts, and collectively termed news) to one or more newsgroups. Users must have access to a news server to use a newsreader.
Ray tracing is a technique that can generate near photo-realistic computer images. A wide range of free software and commercial software is available for producing these images. This article lists notable ray-tracing software. Software.
However, third-party software can decode the lightweight encryption in the device, allowing it to be used as a general-purpose wand-type barcode reader. The CueCat can read several common barcode types, in addition to the proprietary CUE barcodes which had been promoted by Digital Convergence.
Barcode reader. A barcode reader or barcode scanner is an optical scanner that can read printed barcodes and send the data they contain to computer. [1] Like a flatbed scanner, it consists of a light source, a lens, and a light sensor for translating optical impulses into electrical signals.
List of free analog and digital electronic circuit simulators, available for Windows, macOS, Linux, and comparing against UC Berkeley SPICE. The following table is split into two groups based on whether it has a graphical visual interface or not.
ShotCode's software. The software used to read a ShotCode captured by a mobile camera is called ‘ShotReader’. It is lightweight and is only around 17kB. It ‘reads’ the camera’s picture of a ShotCode in real time and prompts the browsers to navigate to a particular site.
Neutron kinetics, thermal-hydraulics, and structural mechanics are all important in this effort. Each software needs to be tested and verified before use. The codes can be separated by use and function. Most of the software are written in C and Fortran.
Interactive geometry software (IGS) or dynamic geometry environments (DGEs) are computer programs which allow one to create and then manipulate geometric constructions, primarily in plane geometry. In most IGS, one starts construction by putting a few points and using them to define new objects such as lines , circles or other points.
This is a list of collaborative code review software that supports the software development practice of software peer review.
Public-domain software with source code. Free and open-source software portal. This category is for software that has been formally released to the public domain, so there is no copyright restriction on it, worldwide.